Home > Exhibition > Content
Corrugated aluminum surface causes
Oct 12, 2016

1. aluminum profile extrusion mold work with length proportion or type cavity size design errors velocity than serious disorders. 2. aluminum profile extrusion mold work with hinder angle and promoting flow angle exists. 3. aluminum profile extrusion mold upper and lower die work with drop than Super poor. 4. aluminum profile extrusion mold upper and lower die work with not parallel, has cough BA mouth. 5. aluminum profile Extrusion die cavity within Shang die resistance (points) flow Taiwan partial high blocked work with out material or drainage slot (size, shades, location) not. 6. aluminum profile extrusion mold work with outside side empty knife too less even no (EDM didn't playing good) or too big (work with no support and cracking deformation). 7. new die or repair had of aluminum profile extrusion mold due to mold factory rough sand polishing work with not are produced of mold work with smooth degree varies. 8. part aluminum profile extrusion work with Shang has oil track. 9. support pad too small hinder. 10. aluminum profile tail end 1M around appeared wave (V3 volume aluminum pressure into).

We're Here to Help

Newsletter

Enter in your email address to receive deals
and coupons.
Bookmark us today!